Getting through winter in a cold rental: condensation and drying washing
By July the windows are streaming every morning, the bathroom ceiling has a grey bloom, and the washing has been on the airer for three days. A cold rental does not have to be an unhealthy one. Most of the fix is managing moisture, and most of that is a handful of habits plus knowing what to ask the landlord for.
This guide draws on Consumer NZ's advice on reducing moisture in the home and Tenancy Services' guidance on mould and dampness. It is practical advice, not a guarantee, and some causes (leaks, poor drainage, no extractor fan) are the landlord's to fix.
Why windows run with water
Warm indoor air holds moisture from cooking, showers, breathing and drying clothes. When it meets a cold surface such as glass or an uninsulated wall, it releases that water as condensation. Over weeks, damp surfaces grow mould. So there are two levers: put less moisture into the air, and keep surfaces warm enough, or air moving enough, that it does not settle.
Wipe, open, repeat
The cheapest habit is the first one. Tenancy Services tells tenants to wipe off condensation, keep the home ventilated and open curtains during the day. Consumer NZ suggests opening windows every day, even in winter, particularly in bathrooms and kitchens, and closing doors to contain steam while you shower or cook.
A routine that works in most flats:
- In the morning, wipe the glass and window frames with a cloth you can wring out outside.
- Open a window in each main room for a few minutes, even if it is cold.
- Use the extractor fan or open a window while showering, and keep the door shut.
- Use pot lids and a rangehood that vents outside when cooking.
Consumer NZ warns against venting extractor fans into the roof or under-floor space, which just moves the problem. If a fan in your rental does that, tell the landlord.
Drying the washing
Indoor drying is the biggest single source of avoidable moisture. Consumer NZ advises drying washing outside where possible for exactly this reason, since a wet load of clothes releases a lot of water into the room as it dries.
Ways to cut it down:
- Dry outside when you can. A line in a sunny spot, or a rack under a covered veranda, garage or carport, is the best option.
- Spin harder. Using the fastest spin speed on your washing machine means less water to evaporate.
- Vent the dryer outside. A clothes dryer with its exhaust hose in the room just adds humidity. Consumer NZ advises venting dryers outside.
- If you must dry indoors, do it in one room with the door closed and a window open or an extractor fan on, rather than spreading airers through the bedrooms.
- Consider a dehumidifier. Consumer NZ says they can help in areas with poor airflow, and that desiccant models do better in colder conditions. They also give off a little heat.
If your rental has no clothesline, ask the landlord whether one can be put up. It is a modest request with a direct link to moisture.
Heating habits
Consumer NZ suggests keeping low levels of heat on most of the time instead of heating hard in short bursts, and aiming for an indoor temperature at least 7°C above outdoors to limit condensation. A steady, moderate warmth means fewer cold surfaces.
Avoid unflued gas and kerosene heaters. Both Consumer NZ and Tenancy Services point out that portable gas heaters release water vapour as they burn, and the vapour feeds the condensation you are trying to avoid. They can also be dangerous without good ventilation. The healthy homes heating standard does not allow unflued combustion heaters as the required heating in a rental. See heating a rental for the standard and for the arithmetic of running costs.
Draughts and curtains
Consumer NZ recommends blocking draughts with seal tape, drawing heavy curtains at night to hold heat, and, where you can influence it, insulation and secondary glazing. In a rental, those bigger jobs are for the landlord, but small steps are within a tenant's reach. Ask before you stick anything to window frames or walls that might damage the finish.
When it is the building, not the household
If mould keeps returning even though you ventilate and heat sensibly, look for causes outside your control:
- A leaking pipe, roof or gutter.
- Overflowing downpipes that wet the wall.
- Damp coming up from the ground under an enclosed floor with no moisture barrier.
- Extractor fans that do not work or vent into the roof space.
Tenancy Services says landlords need to supply a home free from mould and dampness at the start, and under the moisture and drainage standard must provide proper drainage and, where reasonably practicable, a ground moisture barrier in an enclosed subfloor. Report the issue in writing with dated photos, and follow the steps in mould in a rental.
Cleaning mould safely
For small patches on painted surfaces, Tenancy Services suggests half white vinegar and half water, or one part household bleach to three parts water, with gloves, eye protection and a mask. Do not mix products. Consumer NZ cautions that mould in porous materials such as plasterboard, wood and carpet is hard to remove safely and that disturbing it can release spores. If it is spread through the fabric of the wall, it is time to call the landlord rather than scrub.
A winter checklist
- Wipe windows each morning and ventilate for a few minutes.
- Fan or open window every shower and every cook.
- Dry washing outside, or in one ventilated room.
- Keep steady low heat, and shut doors on the room you are heating.
- Photograph mould and damp when it appears.
- Tell the landlord in writing about anything structural.
Tenancy law changes, so check Tenancy Services for the current duties of each side. This is general information and not legal advice.
Sources
- Consumer NZ: ideas for reducing moisture in the home
- Tenancy Services: mould and dampness
- Tenancy Services: heating standard